Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

Forum Jump  
Tool routing
Last post Sun, May 20 2007 by cm, 2 replies.
Options
Go to last post
Posted on Sun, May 20 2007 10:23
by rwtberg
Joined on Sat, May 12 2007, Posts 5
Dear Users,
I've managed to create a setup within a PC and Gigastudio + perf.tool.
But I have a problem.

I've routed the signal (Midioverlan-ports) through the VSLperf. Tool.
MOL11 - vslperf.tool input 1 to gigaport1.. etc.

Inside Gigastudiosystem prefrences I've set all ports to 'none'.
But when I send a midisignal, Gigastudio doesn't receive a signal.
When I set the ports (gigaprefrences) to the direct port (in this case MOL 11 to 16)
Gigastudio does receive the signal.

What should I adjust inside the Performance Tool.

Thank you for your time.

Ps. I've been running two VSL perf.tool patches so I can use all 8 ports of the Gigastudio. (just copied the tool once).

pps. I've created an auto-startup file. So when Windows boots it'll load the presets and the gigafile. Could this perhaps be the problem?


Cal
Posted on Sun, May 20 2007 20:06
by cm
Joined on Fri, Dec 20 2002, vienna, Posts 9027
cal, most if not all giga users don't put giga into the autostart program group, because windows still initializes several devices although you already see the desktop (look for userinit.exe in the processes tab in the taskmanager - if this process disappears, everything is settled).

please check if it makes a difference on your system to launch first the perftool or first gigastudio.
christian
and remember: a CRAY is the only computer that runs an endless loop in just four hours ...
You cannot post new threads in this forum.
You cannot reply to threads in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.