Vienna Symphonic Library Forum
Forum Statistics

182,256 users have contributed to 42,214 threads and 254,734 posts.

In the past 24 hours, we have 2 new thread(s), 23 new post(s) and 45 new user(s).

  1. Home
  2. Software
  3. Vienna Instruments Pro
  4. LOGIC X & VEP5 crashing AU Validation

  • LOGIC X & VEP5 crashing AU Validation

    T
    T
    I recently installed Logic X and have been having no luck getting VEP 5 to pass validation. I have installed the latest version of VEP 5 and have had the same problem. Is there any recommended method to get VEP 5 to pass AU validation in Logic X?
  • G
    G

    Try the following :

     ( Download the latest LOGIC version available( currently 10.0.1 ) if  you haven't done yet . )

    1. Restart your Mac

    2. open the App  "Disk Utility" , select your System Drive and do "Repair Diskpermissions" . This  procedure can take some minutes.

    3. After that , open VEP5 in standalone mode to make sure that it is properly working on your Mac .

     Create a dummy Vi-frame and load a Vienna Instrument . Now close VEP5.

    4. Open Logic X . Usually VEP5 should now be  validated successfully by Logic X's  "AU validation"

    If not , please check Logic X manual "Logic Pro X User Guide" on page 506 and try to select and enable VEPRO5 manually

    in Logic's AU MANAGER , as decribed on that page.

    Hope that helps,

    best

    Gerd
  • T
    T
    Thank you. I will try this and let you know if it works! Best Woody
  • T
    T
    I went through the steps you outlined but I still get crashed validations. Is it possible VEP5 has conflicts with other plugins? Or, is it prefererable to load in VEP before other plugins? W