Hi there,

I'm setting up my percussion slave, and to take a bit of strain off the master, I'm running my reverb on the slave as well. I'm in the process of routing my VSL Percussion instruments into my (Cubase) template, and have created an output for timps, snares, large drums, tuned percussion etc etc.

The signal flow of VEPro seems to demand that an FX track (on a bus) has its own routing, rather than simply returning directly to the origin of where it's sent, do I have this right? If so, I'll have to set up reverbs for each of my routing groups, which is a little processor-intesive, so I'd rather not do that.

Am I misunderstanding something about the signal flow? The manual is a little light on detail here...

Thanks so much for any help!

Mike  

Thanks for replying! Hmm, this will present something of a challenge, as I'm sending many buses out of VEPro and into Cubase (for mixing purposes). I'll have to think of a different routing system.

Cheers

Mike