> FORUMS
> VIENNA SYMPHONIC LIBRARY
> Vienna Instruments & Ensemble Software
> What is the correct procedure for closing Logic sessions when connecting to VE Slave?
Forum Jump
Hi All, I am running Logic 9.1.1 on my Mac Pro and on the SAME machine I'm running Vienna Ensemble Pro OUTSIDE of Logic. All works very well but the problem is that I sometimes have trouble connecting to the VE Pro (via the plugin) slave after closing a logic session. My question is: When I close a Logic session, in which I have connected to the VE using the VE plugin, should I be disconnecting each time? The problem is that in the next logic session, when I open the VE Plugin to connect to the slave, when I click connect the plugin window just comes up blank. I would be most grateful is somebody could tell me if there is a specific protocol for what to do when closing logic session. I did read through the manual but it's all about opening and closing the VE Pro WITHIN logic. I am not running it within but as a slave on the same machine. Any suggestions much appreciated! Felix
|
|
|
|
|
|
Logic has the annoying behavior of not actually closing a project before you either quit Logic or open a new project. Perhaps this is where your problem lies. Try quitting and restarting Logic to make sure the project is really closed. Karel Bassez
Software Engineer
Vienna Symphonic Library
|
|
|
|
|
|
Hi Karel, Thanks very much for your quick response. I'm trying that right now. Best regards, Felix
|
|
|
|
|
|
Or easier still, you just have to select New Project once you've closed the one you were working on, and the connections are all released.
|
|
|
|
|
|
You cannot post new threads in this forum.
You cannot reply to threads in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.