Hi,

I'm experiencing something with the Woodblock instrument from the Full Percussion Library that seems both deliberate but strange. There are 5 Blocks with Block 1 mapped between C2-A#2. The Percussion manual PDF makes no mention of these serving any different purpose other than each Block obviously triggering a different pitched Woodblock. 

However Block #1's C2 (in any Beater) exhibits a strange feature. When I trigger C2 and hold the note until the sample stops sounding (i.e. the Voices display returns to 0) and send the note-off command behaviour is normal. When I lift BEFORE the Voices display returns to 0 I trigger a second Woodblock sample. This behaviour does not seem consistent with the other Block #2- #5 and causes obvious problems when triggering from Sibelius. I can imagine this behaviour might make sense if one wanted a way of triggering the Blocks very quickly but given the inconsitency I suspect that this is an anomoly. 

Any thoughts most welcome...

Thanks!

Juergen 

Thanks Andi,

I actually did a fresh install quite recently but just before the February release of the 5.4 / 2.4 software release. I will update. 

A quick question while I am writing... For some reason I find myself using Vienna Instruments non-pro version in templates and then I wish to switch around the instrument to the PRO version. However when I do this and then reboot Sibelius i seem unable to ensure that the PRO version is retained. Is there a specfic force save function I can use. Saving Playback Configuration seems inconsistent and sometimes the only way I can save is to add a new instrument into the VEP and then erase it again. Is there a better way?

Thanks!

Juergen 

Apologies for late response. Just to say thanks... I hadn't spotted that excellent facility. A real time saver!

Best,

Juergen